1-6 CCNA 4: WAN Technologies v Lab Copyright 2003, Cisco Systems, Inc.Ģ Step 1 Configure the routers Configure all of the following according to the chart: The hostname The console The virtual terminal The enable passwords Step 2 Verifying the ISDN BRI switch type a. Perform those steps on all routers in this lab assignment before continuing. Note: Refer to the erase and reload instructions at the end of this lab. Conduct the following steps on each router unless specifically instructed otherwise. Any other router used may produce slightly different output. The configuration output used in this lab is produced from 1721 series routers. This includes the following and any of their possible combinations: 800 series routers 1600 series routers 1700 series routers 2500 series routers 2600 series routers Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. Any router that meets the interface requirements displayed on the above diagram may be used. Cable a network similar to the one in the diagram above.
If an ISDN router is not available, review the lab and perform as many noninterface commands as possible. An Adtran Atlas550 ISDN emulator is used to simulate the ISDN switch and cloud. Background/Preparation This lab assumes that a router with an ISDN BRI U interface is available.
1 Lab Configuring ISDN BRI (U-Interface) Objective Configure an ISDN router to make a successful connection to a local ISDN switch.
0 kommentar(er)
